Home › ENGINE ยท 2TR-FE › STARTING › STARTER (for 1.7 kW Type)

STARTER (for 1.7 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A122007
  1. Remove the nut, and disconnect the lead wire from the magnet starter switch.



    A122008
  1. Using a T25 "TORX" socket wrench, remove the 3 screws holding the magnet starter switch from the starter drive housing.

  1. Remove the magnet starter switch.

  1. Remove the return spring.



    A122009E01
  1. Remove the plunger from the pinion drive lever.



2. REMOVE STARTER YOKE ASSEMBLY


    A122010
  1. Remove the 2 bolts and starter yoke from the starter drive housing.



    A122011
  1. Remove the plate from the planet carrier.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A122012
  1. Hold the starter yoke in a vise with aluminum plates in between.

    NOTICE:
    Do not overtighten the vise.

  1. Remove the 2 screws and starter commutator end frame cover from the starter commutator end frame.



    A122013E01
  1. Remove the slotted washer.



    A122014E01
  1. Remove the washer.

  1. Remove the starter commutator end frame from the starter yoke.



    A122015E01
  1. Remove the starter brush holder from the starter armature.

    NOTICE:
    Do not pull on the rubber.



4. REMOVE STARTER ARMATURE ASSEMBLY


    A122016E01
  1. Remove the starter armature from the starter yoke.



5. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A122017
  1. Remove the 3 planetary gears from the planet carrier.



    A122018E01
  1. Remove the starter center bearing clutch, pinion drive lever and drive housing cover from the starter drive housing.



    A122019E01
  1. Using a screwdriver, move the pinion stop collar to the starter clutch.



    A122020E01
  1. Using a screwdriver, remove the snap ring.



    A122021
  1. Remove the starter clutch from the planet carrier shaft.



6. REMOVE PLANET CARRIER SHAFT SUB-ASSEMBLY


    A122022
  1. Using 2 screwdrivers, remove the snap ring from the planet carrier shaft.

  1. Remove the washer from the planet carrier shaft.



    A122023E01
  1. Remove the planet carrier shaft from the planet carrier.