STARTER (for 1.7 kW Type) > REASSEMBLY |
| 1. INSTALL PLANET CARRIER SHAFT SUB-ASSEMBLY |
![]() |
Install the planet carrier shaft to the planet carrier.
Install the washer to the planet carrier shaft.
![]() |
Using a screwdriver, install the snap ring to the planet carrier shaft.
| 2. INSTALL STARTER CLUTCH SUB-ASSEMBLY |
![]() |
Apply grease to the spline of the starter clutch and the planet carrier shaft.
Install the starter clutch to the planet carrier shaft.
![]() |
Apply grease to the snap ring and pinion stop collar.
Install the pinion stop collar and new snap ring.
![]() |
Using a vise, compress the snap ring.
![]() |
Using a plastic-faced, lightly tap the planet carrier shaft so that the pinion stop collar is beyond the snap ring while holding the outside of the starter clutch by hand.
![]() |
Install the starter center bearing clutch, pinion drive lever and drive housing cover to the starter drive housing.
![]() |
Apply grease to the planetary gears and pin parts of the planetary shaft.
Install the 3 planetary gears to the planet carrier.
| 3. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Install the armature to the starter yoke.
| 4. INSTALL STARTER BRUSH HOLDER ASSEMBLY |
![]() |
Hold the starter yoke in a vise with aluminum plates in between.
While compressing the spring, install the starter brush holder to the armature.
![]() |
Install the commutator end frame to the starter yoke.
Install the washer to the commutator end frame.
![]() |
Install the slotted washer.
![]() |
Install the commutator end frame cover to the commutator end frame with the 2 screws.
| 5. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Fit the 3 claws of the plate into the 3 grooves of the planet carrier and install the plate to the planet carrier.
![]() |
Align the groove of the yoke and the starter drive housing cover and install the starter yoke to the starter drive housing.
![]() |
Install the starter yoke to the starter drive housing with the 2 bolts.
| 6. INSTALL MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Apply grease to the hook.
Install the plunger to the pinion drive lever.
![]() |
Install the return spring to the magnet starter switch.
Using a T25 "TORX" socket wrench, install the magnet starter switch with the 3 screws.
![]() |
Connect the lead wire to the terminal with the nut.