Home › BRAKE › BRAKE CONTROL › YAW RATE AND DECELERATION SENSOR (w/ VSC)

YAW RATE AND DECELERATION SENSOR (w/ VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT SEAT ASSEMBLY
  1. for Manual Seat:
    (Click here)

  1. for Power Seat:
    (Click here)



3. REMOVE FLOOR CARPET COVER


    C189946
  1. Detach the 4 claws and remove the floor carpet cover.



4. REMOVE SENSOR BRACKET
  1. Remove the 2 bolts and sensor bracket.



5. REMOVE YAW RATE SENSOR ASSEMBLY


    C189947E01
  1. Remove the yaw rate sensor.

  1. Disconnect the connector.