Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR (w/ VSC)

STEERING ANGLE SENSOR (w/ VSC) > INSTALLATION

for Preparation Click here



1. INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

NOTICE:
  1. Do not replace the spiral cable with the battery connected and the ignition switch ON.
  2. Do not rotate the spiral cable with the battery connected and the ignition switch ON.
  3. Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
  4. Do not remove the steering angle sensor from the spiral cable.



2. INSTALL STEERING COLUMN UPPER COVER


3. INSTALL STEERING COLUMN LOWER COVER


H046251
  1. Install the cover with the 3 screws.



4. POSITION SPIRAL CABLE


H045494
  1. Slowly rotate the spiral cable counterclockwise by hand until it feels firm.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.



    B110261E01
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to the left and right from the center.



5. INSTALL STEERING WHEEL ASSEMBLY



6. INSTALL STEERING PAD



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



8. CHECK SRS WARNING LIGHT