Home › BRAKE › BRAKE CONTROL › STEERING ANGLE SENSOR (w/ VSC)

STEERING ANGLE SENSOR (w/ VSC) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE STEERING PAD ASSEMBLY



4. REMOVE STEERING WHEEL ASSEMBLY



5. REMOVE STEERING COLUMN LOWER COVER


H046251
  1. Remove the 3 screws and cover.



6. REMOVE STEERING COLUMN UPPER COVER


7. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

NOTICE:
  1. Do not replace the spiral cable with the battery connected and the ignition switch ON.
  2. Do not rotate the spiral cable with the battery connected and the ignition switch ON.
  3. Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
  4. Do not remove the steering angle sensor from the spiral cable.