Vehicle Condition
| Auto Cancel Condition
| Fail-safe Deactivation Condition
|
CRUISE main indicator light blinks
| - There is an open or short in the stop light switch circuit
- There is a problem with the vehicle speed signal
| Turn the cruise control main switch on again
|
CRUISE main indicator light blinks
| - There is a problem with the input circuit of the stop light switch circuit
- There is a problem with the cancel circuit
- There is a problem with the ECD system*2
| Turn the ignition switch off and then on again
|
CRUISE main indicator light remains on (Cruise control is canceled)
| Under the following conditions, the stored vehicle speed is maintained:
- The vehicle speed is less than the low speed limit (approximately 40 km/h (25 mph)) while running with the cruise control on
| Push the cruise control main switch to +RES
|
- The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more
| Push the cruise control main switch to -SET
|
CRUISE main indicator light goes off
| There is a problem with the throttle position sensor and motor*1
| Turn the cruise control main switch on again after the throttle position sensor and motor returns to normal
|
There is a problem with the fuel injection system*2
| Fuel injection system returns to normal
|