Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV with i-ART)

DTC    P0560    System Voltage

for Preparation Click here


DESCRIPTION

The battery supplies power to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the TCM will illuminate the MIL and store the DTC.

DTC Code
DTC Detection Condition
Trouble Area
P0560
Open in the TCM back-up power source circuit (1-trip detection logic).
  1. Open in back-up power source circuit
  2. TCM

HINT:
If DTC P0560 is stored, the TCM does not store other DTCs.


WIRING DIAGRAM


C156221E12


INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (ECD SYSTEM DTC P0560)
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / ECT / Trouble Codes.

  1. Read the DTCs using the GTS.
    Result 
    Result
    Proceed to
    DTCs are not output
    A
    P0560 is output (ECD system)
    B



B
GO TO ECD SYSTEM (DTC P0560) (Click here)
A


2.CHECK TCM (BATTERY, GROUND)


    C216560E15
  1. Disconnect the TCM connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T35-5 (BATT) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Rear view of wire harness connector
(to TCM)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, GROUND)
OK

REPLACE TCM (Click here)