DTC P0560 System Voltage |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Ignition switch to ON for 3 seconds | The voltage at terminal BATT drops excessively for 3 seconds and part of the stored values in the ECM are initialized (1 trip detection logic). |
|
| DTC No. | Data List |
| P0560 | Battery Voltage* |

| 1.CHECK ECM TERMINAL VOLTAGE (BATT) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E5-2 (BATT) - Body ground | Always | 11 to 14 V |
| *a | Component with harness connected (ECM) |
|
| ||||
| OK | |
| 2.INSPECT BATTERY |
Check that the battery is not depleted.
|
| ||||
| OK | |
| 3.CHECK BATTERY TERMINAL |
Check that the battery terminals are not loose or corroded.
|
| ||||
| OK | |
| 4.CHECK WHETHER DTC OUTPUT RECURS |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON and turn the tester on.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON for 3 seconds.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| P0560 is output | A |
| No DTC is output | B |
|
| ||||
| A | |
| 5.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
|
| ||||
| 7.RECHARGE OR REPLACE BATTERY |
Recharge or replace the battery.
|
| ||||
| 8.REPAIR OR REPLACE BATTERY TERMINAL |
Repair or replace the battery terminal.
| NEXT | |
| 9.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 3 seconds.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||