DTC P0560 System Voltage |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0560 | Open in the TCM back-up power source circuit (1-trip detection logic). |
|

| 1.CHECK DTC OUTPUT (ECD SYSTEM DTC P0560) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Read the DTCs using the GTS.
| Result | Proceed to |
| DTCs are not output | A |
| P0560 is output (ECD system) | B |
|
| ||||
| A | |
| 2.CHECK TCM (BATTERY, GROUND) |
![]() |
Disconnect the TCM connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T35-5 (BATT) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T19-1 (E1) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||