Home › ENGINE ยท 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (for i-ART)

DTC    P0630    VIN not Programmed or Mismatch - ECM / PCM

for Preparation Click here


DESCRIPTION

DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM, or the input VIN is incorrect. The VIN is input with the GTS.

DTC No.
DTC Detection Condition
Trouble Area
P0630
Either condition is met (1 trip detection logic):
  1. VIN is not stored in the ECM.
  2. Input VIN is incorrect.
ECM

INSPECTION PROCEDURE

1.READ OUTPUT DTC (CURRENT DTC)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the GTS on.

  1. Enter the following menus: Powertrain / Engine / Trouble Codes.

  1. Read DTCs.

    Result 
    Result
    Proceed to
    DTC P0630 is output
    A
    DTC P0630 and other DTCs are output
    B

    HINT:
    If any DTCs other than P0630 are output, troubleshoot those DTCs first.

NOTICE:
If P0630 is stored, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when the VIN is input. If DTCs other than P0630 are output, troubleshoot them first.



B
GO TO DTC CHART (Click here)
A


2.INPUT VIN WITH GTS
  1. Refer to Registration (Click here).


NEXT

END