ECD SYSTEM (w/ EGR Cooler) > PRECAUTION |
| 1.INITIALIZATION AND REGISTRATION |
| Replacement Part | Utility Item |
| ECM |
|
| Engine assembly |
|
| Fuel supply pump assembly | Supply Pump Initialization (Click here) |
| Injector assembly |
|
| 2.INJECTOR COMPENSATION CODE |
![]() |
When an injector assembly is replaced, the injector compensation code must be input into the ECM .
| *a | Example |
| *b | Injector Compensation Code |
When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM .
| 3.PILOT QUANTITY LEARNING |
When an injector assembly is replaced, the injector compensation code must be input to the ECM, and then pilot quantity learning must be performed .
When the ECM is replaced, all of the existing injector pilot quantity learning values must be input into the new ECM .
| 4.ENGINE DIFFICULT TO START, ENGINE STALLING, BLACK SMOKE EMITTED, ROUGH IDLING, EXCESSIVE ENGINE VIBRATION, ENGINE KNOCKING, LACK OF POWER OR HESITATION |
Check if the customer problem is described below. If so, refer to the appropriate troubleshooting section.
Engine is difficult to start or stalling.
Black smoke is emitted.
There is rough idling or excessive engine vibrations.
There is engine knocking or rattling.
There is a lack of power or hesitation.
| 5.WHEN USING INTELLIGENT TESTER |