Home › ENGINE · 1KD-FTV › ENGINE CONTROL SYSTEM › ECD SYSTEM (w/o EGR Cooler)

ECD SYSTEM (w/o EGR Cooler) > Starter Signal Circuit

for Preparation Click here


DESCRIPTION

While the engine is being cranked, current flows from terminal ST2 of the ignition switch to the ST fuse and also flows to terminal STA of the ECM (STA signal).

WIRING DIAGRAM

Refer to DTC P0617 .

INSPECTION PROCEDURE

HINT:
This chart is based on the premise that the engine can crank normally. If the engine cannot crank normally, proceed to the problem symptoms table (Click here).

NOTICE:
If the ECM is replaced, the new ECM needs initialization (Click here).

1.READ VALUE USING INTELLIGENT TESTER (STARTER SIG)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch ON and turn the intelligent tester ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Starter Signal.

  1. Read the values.

    OK:
    Ignition Switch Position
    Starter SIG
    ON
    OFF
    START
    ON



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK WIRE HARNESS (ECM - STARTER RELAY (Marking: ST))


    A198816E04
  1. Disconnect the E4 ECM connector.

  1. Remove the starter relay from the engine room relay block.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance :
    Tester Connection
    Specified Condition
    Relay block starter relay terminal 1 - E4-7 (STA)
    Below 1 Ω
    Relay block starter relay terminal 1 or E4-7 (STA) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM (Click here)