ECD SYSTEM > INITIALIZATION |
| DIESEL THROTTLE BODY INITIALIZATION PROCEDURE |
Turn the ignition switch to ON.
Turn the ignition switch off and wait for 30 seconds or more.
Turn the ignition switch to ON and wait for 10 seconds or more.
| SUPPLY PUMP INITIALIZATION PROCEDURE |
![]() |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Supply Pump Initialization.
Press "Next".
![]() |
Press "Next".
![]() |
Press "Exit".
Start the engine to check if the initialization is complete. If the engine cannot be started, repeat the initialization procedures from the beginning (Procedure "A").
Idle the engine for at least 1 minute under the following conditions: (Procedure "B")
Initialization is complete.