ECD SYSTEM (for i-ART) > INITIALIZATION |
| INITIALIZATION PROCEDURE FOR DIESEL THROTTLE BODY ASSEMBLY, ELECTRIC EGR CONTROL VALVE ASSEMBLY AND TURBOCHARGER SUB-ASSEMBLY |
Turn the ignition switch to ON.
Turn the ignition switch off and wait for 30 seconds or more.
Turn the ignition switch to ON and wait for 10 seconds or more.
| SUPPLY PUMP INITIALIZATION PROCEDURE |
![]() |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Utility / Supply Pump Initialization.
Press "Next".
![]() |
Press "Next".
![]() |
Press "Exit".
Start the engine to check if the initialization is complete. If the engine cannot be started, repeat the initialization procedures from the beginning (Procedure "A").
Idle the engine for at least 1 minute under the following conditions: (Procedure "B")
Initialization is complete.
| CRANK TIME COMPENSATION RESET FUNCTION |
![]() |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Utility / Crank Time Compensation Reset.
![]() |
When the first screen is displayed, check the vehicle condition and push "Next".
![]() |
When the screen indicating reset completion is displayed, push "Exit".
| i-ART Learning Value Reset |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Utility / i-ART Learning Value Reset.
After confirming the following conditions, proceed to the next step:
Select the cylinder to be reset.
Press "Next".
If the reset fails, confirm the following conditions and perform the reset again.
Turn the ignition switch to ON.
Turn the ignition switch off and wait for 30 seconds or more.
Turn the ignition switch to ON and wait 3 minutes or more.
Battery voltage is 8 V or more.
When the screen indicating reset completion is displayed, push "Exit".