FUEL PRESSURE PULSATION DAMPER > INSTALLATION |
| 1. INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY |
![]() |
Apply a light coat of gasoline or spindle oil to the O-ring.
Install the fuel pressure pulsation damper with the 2 bolts.
| 2. CONNECT NO. 1 FUEL HOSE |
Connect the No. 1 fuel hose (Click here).
| 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 4. INSPECT FOR FUEL LEAK (for Fuel Main Tank) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Push the intelligent tester main switch on.
Select the Active Test and enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check for fuel leaks.
Check that there are no fuel leaks after performing maintenance anywhere on the fuel system.
If there are fuel leaks, repair or replace parts as necessary.