Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Connecting terminals 13 (TC) and 4 (CG) of the DLC3 causes the system to enter self-diagnostic mode. If a malfunction is present, DTCs will be output.

HINT:
When a particular warning light continues blinking, a ground short in the wiring of terminal 13 (TC) of the DLC3 or an internal ground short in the relevant ECU is suspected.


WIRING DIAGRAM


E173773E05


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (DLC3 - ECM AND BODY GROUND)

E251525E01

  1. *1: for 1GR-FE
  2. *2: for 1KD-FTV (except i--ART)
  3. *3: for 1KD-FTV (for i--ART)
  1. Disconnect the E14*1, E4*2 or E31*3 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 1GR-FE:
    Tester Connection
    Condition
    Specified Condition
    D3-13 (TC) - E14-23 (TC)
    Always
    Below 1 Ω
    D3-13 (TC) - Body ground
    Always
    10 kΩ or higher
    D3-4 (CG) - Body ground
    Always
    Below 1 Ω
    for 1KD-FTV (except i-ART):
    Tester Connection
    Condition
    Specified Condition
    D3-13 (TC) - E4-11 (TC)
    Always
    Below 1 Ω
    D3-13 (TC) - Body ground
    Always
    10 kΩ or higher
    D3-4 (CG) - Body ground
    Always
    Below 1 Ω
    for 1KD-FTV (for i-ART):
    Tester Connection
    Condition
    Specified Condition
    D3-13 (TC) - E31-23 (TC)
    Always
    Below 1 Ω
    D3-13 (TC) - Body ground
    Always
    10 kΩ or higher
    D3-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM