Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ECM

ECM > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


B278058E01
  1. Slightly bend the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door until it is horizontal.
    Text in Illustration 
    *1
    Stopper



    B278059E01
  1. Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.
    Text in Illustration 
    *1
    Hinge



4. REMOVE ECM


    A118435
  1. Disconnect the 4 connectors.

  1. Remove the bolt, 2 nuts and ECM.



5. REMOVE NO. 1 ECM BRACKET


    A118429
  1. Remove the 2 screws and bracket.



6. REMOVE NO. 2 ECM BRACKET


    A118430
  1. Remove the 2 screws and bracket.