Home › ENGINE ยท 2TR-FBE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
  1. Install a new gasket to the sensor.

  1. Install the sensor.

    Torque:
    20 N*m{ 200 kgf*cm , 14 ft.*lbf }

  1. Connect the sensor connector.



2. INSTALL INTAKE MANIFOLD


    G039042E03
  1. Install a new gasket and the intake manifold with the 5 bolts and 2 nuts.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

  1. Connect the purge line hose and purge VSV connector.

  1. Connect the vacuum hose.



3. INSTALL STARTER ASSEMBLY
  1. Install the starter with the 2 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Install the starter wire to terminal 30 with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Connect the terminal cap.

  1. Connect the starter connector.



4. INSTALL THROTTLE BODY
(Click here)


5. INSPECT FOR FUEL LEAK (for Fuel Sub Tank)
  1. Start the engine.

    NOTICE:
    Perform the inspection while the engine is cold.
    The fuel pump operates only for a certain amount of time when the coolant temperature is 20°C (68°F) or less and the learned ethanol concentration is 85% or more.

  1. Check for fuel leaks.

    1. Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.