Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.



  1. Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A112146E01



4. REMOVE INTAKE AIR CONNECTOR
  1. Disconnect the vacuum hose.

  1. Disconnect the No. 2 PCV hose.

  1. Loosen the 2 hose clamps, and then remove the 2 bolts and intake air connector.



5. REMOVE STARTER ASSEMBLY


    G039103E03
  1. Disconnect the starter connector.

  1. Disconnect the terminal cap.

  1. Remove the nut and disconnect the starter wire.

  1. A/T:
    Remove the 2 bolts and A/T oil dipstick.

  1. M/T:
    Remove the clutch release cylinder.

  1. Remove the 2 bolts and starter.



6. REMOVE THROTTLE BODY
  1. Disconnect the throttle position sensor and control motor connector.

  1. Disconnect the 2 water by-pass hoses.



    A086829E01
  1. Remove the 2 bolts, 2 nuts and throttle body.

  1. Remove the gasket.



7. REMOVE INTAKE MANIFOLD


    G039042E03
  1. Disconnect the vacuum hose.

  1. Disconnect the purge line hose and purge VSV connector.

  1. Remove the 5 bolts, 2 nuts, intake manifold and gasket.



8. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A111697
  1. Disconnect the sensor connector.

  1. Remove the sensor.

  1. Remove the gasket from the sensor.