Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD


    A099092E01
  1. Install the accelerator pedal rod with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    This accelerator pedal does not require lubrication.
    Do not apply oil or other lubrication to the accelerator pedal rod.
    If applied, the accelerator pedal rod must be replaced.

  1. Connect the accelerator pedal position sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


3. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.