Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE ACCELERATOR PEDAL ROD


    A099092E01
  1. Disconnect the accelerator pedal position sensor connector.

  1. Remove the 2 bolts and accelerator pedal rod.

    NOTICE:
    1. Do not drop or strike the accelerator pedal rod.
    2. Do not disassemble the accelerator pedal rod.
    3. This accelerator pedal does not require lubrication.
      Do not apply oil or other lubrication to the accelerator pedal rod.
      If applied, the accelerator pedal rod must be replaced.