THROTTLE BODY > INSTALLATION |
| 1. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY |
![]() |
Install a new gasket on the intake manifold.
Install the throttle body with motor with the 2 bolts and 2 nuts.
Connect the 2 water by-pass hoses to the throttle body with motor.
Connect the throttle position sensor and control motor connector.
| 2. INSTALL INTAKE AIR CONNECTOR |
Install the intake air connector with the 2 bolts, and tighten the 2 hose clamps.
Connect the vacuum hose.
Connect the No. 2 ventilation hose.
| 3. ADD ENGINE COOLANT |
Tighten all the plugs and fill the radiator with TOYOTA Super Long Life Coolant (SLLC).
| Item | Specified Condition |
| A/T | 8.1 liters (8.6 US qts, 7.1 Imp. qts) |
| M/T | 7.8 liters (8.2 US qts, 6.9 Imp. qts) |
Fill the radiator reservoir with TOYOTA SLLC to the F line.
Press the inlet and outlet radiator hoses several times by hand, and then check the level of the coolant.
If the coolant level drops below the F line, add TOYOTA SLLC to the F line.
Install the radiator cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens.
While the thermostat is open, circulate the coolant for several minutes.
Maintain the engine speed at 2500 to 3000 rpm.
Press the inlet and outlet radiator hoses several times by hand to bleed air.
Stop the engine and wait until the coolant cools down to ambient temperature.
Check the coolant level in the radiator reservoir.
If the coolant level is below the L line, add SLLC up to the reservoir F line.
| 4. PERFORM INITIALIZATION |
Disconnect the EFI and ETCS fuses at the same time. Wait at least 60 seconds and reconnect the fuses.
Turn the ignition switch to ON without operating the accelerator pedal.
Connect the tester to the DLC3 and clear the DTCs (Click here).
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the cooler is switched off after the engine is warmed up.
| Condition | Specified Condition |
| Air conditioning switched off | 600 to 700 rpm |
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.
Perform a road test and confirm that there are no abnormalities.
| 5. INSPECT FOR COOLANT LEAKS |
Fill the radiator with coolant and attach a radiator cap tester.
Warm up the engine.
Using a radiator cap tester, increase the pressure inside the radiator to 118 kPa (1.2 kgf/cm2, 17 psi), and check that the pressure does not drop.
If the pressure drops, check the hoses, radiator and water pump for leaks. If no external leaks are found, check the cylinder block and cylinder head.