THROTTLE BODY > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. DRAIN ENGINE COOLANT |
Remove the radiator cap.
Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

| 4. REMOVE INTAKE AIR CONNECTOR |
Disconnect the vacuum hose.
Disconnect the No. 2 PCV hose.
Loosen the 2 hose clamps, and then remove the 2 bolts and intake air connector.
| 5. REMOVE THROTTLE BODY |
Disconnect the throttle position sensor and control motor connector.
Disconnect the 2 water by-pass hoses.
![]() |
Remove the 4 bolts and throttle body.
Remove the gasket.