Home › ENGINE ยท 2TR-FBE › ENGINE CONTROL SYSTEM › THROTTLE BODY

THROTTLE BODY > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT
  1. Remove the radiator cap.

    CAUTION:
    Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



  1. Loosen the cylinder block drain cock plug and radiator drain cock plug to drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A263383E01



2. REMOVE INTAKE AIR CONNECTOR
  1. Disconnect the No. 2 ventilation hose.

  1. Disconnect the vacuum hose.

  1. Loosen the 2 hose clamps and remove the 2 bolts and disconnect the intake air connector.



3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
  1. Disconnect the throttle position sensor and control motor connector.

  1. Disconnect the 2 water by-pass hoses.



    A309649
  1. Remove the 4 bolts and throttle body with motor.

  1. Remove the gasket from the intake manifold.