Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE DRIVE BELT


A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.



4. REMOVE IDLER PULLEY (w/o Air Conditioning System)


    A121584
  1. Remove the 3 bolts and idler pulley.



5. REMOVE GENERATOR ASSEMBLY (w/ Air Conditioning System)


A112761
  1. Disconnect the terminal cap.

  1. Remove the 2 bolts, nut and generator wire.

  1. Disconnect the generator connector.

  1. Remove the 2 bolts and generator.



6. DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)


    A112977
  1. Remove the 2 bolts and disconnect the suction hose from the engine.



    A112978
  1. Disconnect the cooler compressor connector.

  1. Remove the 4 bolts and disconnect the compressor from the engine.

  1. Support the cooler compressor securely.



7. REMOVE CRANKSHAFT POSITION SENSOR


    A076417E01
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.