Home › ENGINE ยท 2TR-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE CAMSHAFT POSITION SENSOR


    A099146E01
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.