ECD SYSTEM (w/o EGR Cooler) > Pre-heating Control Circuit |



| 1.INSPECT GLOW RELAY (Marking: GLOW) |
![]() |
Remove the glow relay from the engine room relay block.
Measure the resistance of the relay.
| Tester Connection | Specified Condition |
| 3 - 5 | 10 kΩ or higher |
| Below 1 Ω (when battery voltage is applied to terminals 1 and 2) |
|
| ||||
| OK | |
| 2.INSPECT FUSE (GLOW) |
![]() |
Remove the GLOW H-fuse from the engine room junction block.
Measure the resistance of the H-fuse.
|
| ||||
| OK | |
| 3.INSPECT GLOW PLUG ASSEMBLY (RESISTANCE) |
![]() |
Disconnect the glow plug wire.
Measure the resistance of the glow plugs.
| Tester Connection | Condition | Specified Condition |
| Glow plug terminal - Body ground | 20°C (68°F) | Approximately 0.95 Ω |
|
| ||||
| OK | |
| 4.CHECK GLOW PLUG ASSEMBLY (INSTALLATION) |
Check the glow plug installation.
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS (GLOW RELAY (Marking: GLOW) - ECM AND BODY GROUND) |
![]() |
Disconnect the E4 ECM connector.
Remove the glow relay from the engine room relay block.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| E4-15 (GREL) - Relay block glow relay terminal 2 | Below 1 Ω |
| Relay block glow relay terminal 1 - Body ground | Below 1 Ω |
| E4-15 (GREL) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK WIRE HARNESS (GLOW RELAY (Marking: GLOW) - GLOW PLUG AND BATTERY) |
![]() |
Remove the glow relay from the engine room relay block.
Disconnect the G1 glow plug connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| Relay block glow relay terminal 3 - Glow plug wire connector | Below 1 Ω |
| Relay block glow relay terminal 5 - Positive (+) battery terminal cable | Below 1 Ω |
|
| ||||
| OK | |
| 7.CHECK ECM (GREL VOLTAGE) |
![]() |
Start the engine.
Measure the voltage of the ECM connectors.
| Tester Connection | Condition | Specified Condition |
| E4-15 (GREL) - E6-7 (E1) | Engine coolant temperature 40°C (104°F) or less | 9 to 14 V |
|
| ||||
| OK | |
| 8.CHECK ECM (BATT VOLTAGE) |
![]() |
Measure the voltage of the ECM connectors.
| Tester Connection | Specified Condition |
| E5-2 (BATT) - E6-7 (E1) | 9 to 14 V |
|
| ||||
| OK | ||
| ||