AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV with i-ART) > DTC CHECK / CLEAR |
| CHECK DTC |
DTCs which are stored in the TCM can be output to the GTS.
The GTS can display pending DTCs and current DTCs. Some DTCs are not stored unless a malfunction is detected in consecutive driving cycles. When a malfunction is detected in only one driving cycle, it is stored as a pending DTC.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Trouble Codes.
Confirm the DTCs and freeze frame data, and then write them down.
Confirm the details of the DTCs (Click here).
| CLEAR DTC (using GTS) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Trouble Codes / Clear.
Clear the DTCs.
| CLEAR DTC (without using GTS) |
Perform either of the following operations.
Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
Remove the EFI fuse from the engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.