AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| MEASURE LINE PRESSURE |
![]() |
Warm up the ATF.
Remove the test plug on the transmission case center right side and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot firmly on the brake pedal and move the shift lever to D.
Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest line pressure reading when the engine speed reaches stall speed.
Perform the measure line pressure test again with the shift lever on R.
| Condition | Shift Lever on D | Shift Lever on R |
| Stall | 1350 to 1500 kPa (13.8 to 15.3 kgf/cm2, 196 to 218 psi) | 1250 to 1550 kPa (12.7 to 15.8 kgf/cm2, 181 to 225 psi) |
| Problem | Possible Cause |
| Measured values at all positions are higher than specified |
|
| Measured values at all positions are lower than specified |
|
| Pressure is low when shift lever is on D only |
|
| Pressure is low when shift lever is on R only |
|