Home › TRANSMISSION ยท A343E AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 2TR-FBE)

AUTOMATIC TRANSMISSION SYSTEM (for 2TR-FBE) > HYDRAULIC TEST

for Preparation Click here



MEASURE LINE PRESSURE
C190894E01

NOTICE:
  1. Perform the test at the normal operating ATF temperature: 50 to 80°C (122 to 176°F).
  2. The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels and wheel chocks while the other is performing the test.
  3. Be careful to prevent SST's hose from interfering with the exhaust pipe.
  4. This test must be performed after checking and adjusting the engine.
  5. Perform the test with the A/C off.

  1. Warm up the ATF.

  2. Remove the test plug from the transmission case and connect SST.

    SST
    09992-00095   (09992-00231, 09992-00271)

  3. Fully apply the parking brake and chock the 4 wheels.

  4. Start the engine and check the idling speed.

  5. Keep your left foot firmly on the brake pedal and move the shift lever to D.

  6. Measure the line pressure when the engine is idling.

  7. Depress the accelerator pedal as much as possible with your right foot. Quickly read the highest line pressure reading when the engine speed reaches stall speed.

  8. Perform the measure line pressure test again with the shift lever on R.

    Specified line pressure: 
    Condition
    Shift Lever on D
    Shift Lever on R
    Stall
    1050 to 1250 kPa
    (10.7 to 12.7 kgf/cm2, 152 to 181 psi)
    1400 to 1750 kPa
    (14.3 to 17.8 kgf/cm2, 203 to 254 psi)

    Evaluation: 
    Problem
    Possible Cause
    Measured values at all positions are higher than specified
    1. Shift solenoid valve SLT defective
    2. Regulator valve defective
    Measured values at all positions are lower than specified
    1. Shift solenoid valve SLT defective
    2. Regulator valve defective
    3. Oil pump defective
    4. O/D direct clutch defective
    Pressure is low when shift lever is on D only
    1. D position circuit fluid leak
    2. Forward clutch defective
    Pressure is low when shift lever is on R only
    1. R position circuit fluid leak
    2. Direct clutch defective
    3. 1st and reverse brake defective