AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV without i-ART) > HYDRAULIC TEST |
| PERFORM HYDRAULIC TEST |
Measure the line pressure.
Warm up the ATF (Automatic Transmission Fluid).
Turn the ignition switch off.
Lift the vehicle up.
![]() |
Remove the test plug from the transmission case and connect SST.
Lower the vehicle.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check the idling speed.
Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.
Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches stall speed.
In the same manner, perform the test with the shift lever in R.
| Condition | D Position | R Position |
| Stall speed | 1200 to 1450 kPa (12.2 to 14.8 kgf/cm2, 174 to 210 psi) | 1150 to 1450 kPa (11.7 to 14.8 kgf/cm2, 167 to 210 psi) |
| Problem | Possible Cause |
| Measured values at all positions are higher than specified pressure |
|
| Measured values at all positions are below specified pressure |
|
| Pressure is low in D only |
|
| Pressure is low in R only |
|