DTC P0711 Transmission Fluid Temperature Sensor "A" Performance |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0711 | Either condition is met: 1. (a), (b) and (c) are detected (2-trip detection logic): (a) Vehicle has been driven normally for 39 minutes and 9.2 km (5.8 miles) or more. (b) Intake air and engine coolant temperatures are -10°C (14°F) or higher 12 seconds after the engine is started. (c) ATF temperature is below 20°C (68°F). 2. Both (a) and (b) are detected (2-trip detection logic): (a) Engine coolant temperature is below 35°C (95°F) after the engine is started. (b) ATF temperature is 95°C (203°F) or higher when the engine coolant temperature reaches 60°C (140°F) after 10 sec. or more. | No. 1 ATF temperature sensor (transmission wire) |
| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| A/T Oil Temperature 1 | No. 1 ATF temperature sensor value/ Min.: -40.0°C (-40.0°F) Max.: 215.0°C (419.0°F) |
| If the value is -40°C (-40°F) or 215°C (419°F), the No. 1 ATF temperature sensor circuit is open or shorted. |
| Temperature Displayed | Malfunction |
| -40°C (-40°F) | Open circuit |
| 150°C (302°F) or higher | Short circuit |
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0711) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
| Only P0711 is output | A |
| P0711 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION FLUID LEVEL |
Check the transmission fluid level (Click here).
|
| ||||
| OK | ||
| ||