DTC P0724 Brake Switch "B" Circuit High |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0724 | Stop light switch remains on even when the vehicle is driven in a stop (less than 3 km/h (2 mph)) and go (30 km/h (19 mph) or more) pattern 5 times (2-trip detection logic). |
|

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light switch status/ ON or OFF |
| - |
| 1.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin pushed (pedal released) | 10 kΩ or higher |
| 3 - 4 | Pin not pushed (pedal depressed) | 10 kΩ or higher |
| 1 - 2 | Pin not pushed (pedal depressed) | Below 1 Ω |
| 3 - 4 | Pin pushed (pedal released) | Below 1 Ω |
| *1 | Pin |
| *a | Component without harness connected (Stop Light Switch) |
| *b | Not pushed |
| *c | Pushed |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TCM - BATTERY) |
![]() |
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T35-14 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| T35-14 (STP) - Body ground | Brake pedal released | Below 1 V |
| *a | Rear view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||