DTC P0724 Brake Switch "B" Circuit High |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0724 | Stop light switch remains on even when the vehicle is driven in a stop (less than 3 km/h (2 mph)) and go (30 km/h (19 mph) or more) pattern 5 times (2-trip detection logic). |
|

| DATA LIST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / ECT / Data List.
According to the display on the tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light switch status/ ON or OFF |
| - |
| 1.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch assembly (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin pushed (pedal released) | 10 kΩ or higher |
| 3 - 4 | Pin not pushed (pedal depressed) | 10 kΩ or higher |
| 1 - 2 | Pin not pushed (pedal depressed) | Below 1 Ω |
| 3 - 4 | Pin pushed (pedal released) | Below 1 Ω |
| *1 | Pin |
| *a | Component without harness connected (Stop Light Switch Assembly) |
| *b | Not pushed |
| *c | Pushed |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (TCM - BATTERY) |
![]() |
Disconnect the TCM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| T35-14 (STP) - Body ground | Brake pedal depressed | 11 to 14 V |
| T35-14 (STP) - Body ground | Brake pedal released | Below 1 V |
| *a | Rear view of wire harness connector (to TCM) |
|
| ||||
| OK | ||
| ||