DTC P0751 Shift Solenoid "A" Performance (Shift Solenoid Valve S1) |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0751 | S1 stuck ON malfunction*1: The ECM determines there is a malfunction when the following conditions are both met (2-trip detection logic): (a) When the ECM directs the transmission to switch to 3rd gear, the actual gear is shifted to 2nd. (b) When the ECM directs the transmission to switch to 4th gear, the actual gear is shifted to 1st. |
|
| P0751 | S1 stuck OFF malfunction*2: The ECM determines there is a malfunction when the following conditions are both met (2-trip detection logic): (a) When the ECM directs the transmission to switch to 1st gear, the actual gear is shifted to 4th. (b) When the ECM directs the transmission to switch to 4th gear, the actual gear is shifted to 4th. |
|
| ECM gear shift command | 1st | 2nd | 3rd | 4th |
| *1: Actual gear position under S1 stuck ON malfunction | 1st | 2nd | 2nd | 1st |
| *2: Actual gear position under S1 stuck OFF malfunction | 4th | 3rd | 3rd | 4th |
| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
According to the display on the tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Control the Shift Position | Operate shift solenoid valves and set each shift position |
| Possible to check operation of the shift solenoid valves. [Vehicle Condition] 50 km/h (30 mph) or less |
| ECM gear shift command | 1st | 2nd | 3rd | 4th |
| Shift solenoid valve S1 | ON | ON | OFF | OFF |
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0751) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the intelligent tester.
| Result | Proceed to |
| Only P0751 is output | A |
| P0751 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE S1 |
![]() |
Remove shift solenoid valve S1.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Shift solenoid valve S1 connector terminal - Shift solenoid valve S1 body | 20°C (68°F) | 11 to 15 Ω |
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
| Valve moves and makes an operating noise |
| *a | Component without harness connected (Shift Solenoid Valve S1) |
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly (Click here).
|
| ||||
| OK | ||
| ||