DTC P0604 Internal Control Module Random Access Memory (RAM) Error |
DTC P0606 ECM / PCM Processor |
DTC P060A Internal Control Module Monitoring Processor Performance |
DTC P060D Internal Control Module Accelerator Pedal Position Performance |
DTC P060E Internal Control Module Throttle Position Performance |
DTC P0657 Actuator Supply Voltage Circuit / Open |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0604 P0606 P060A P060D P060E P0657 | ECM internal error (1 trip detection logic) | ECM |
| 1.READ OUTPUT DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Clear the DTCs.
Turn the ignition switch off and turn the tester off.
Disconnect the tester.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs.
| Result | Proceed to |
| DTCs P0604, P0606, P060A, P060D, P060E and/or P0657 are output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||