Home › ENGINE · 1GR-FE › ENGINE CONTROL SYSTEM › FUEL PUMP RELAY

FUEL PUMP RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FUEL PUMP RELAY (Marking: F-PMP/FFV)
  1. Remove the engine room relay block cover.

  1. Remove the fuel pump from the engine room junction block.



4. INSPECT FUEL PUMP RELAY


A087121E01
  1. Measure the resistance of the fuel pump relay.

    Standard Resistance:
    Tester Connection
    Specified Condition
    3 - 4
    Below 1 Ω
    3 - 5
    10 kΩ or higher
    3 - 4
    10 kΩ or higher
    (when battery voltage is applied to terminals 1 and 2)
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the fuel pump relay.



5. INSTALL FUEL PUMP RELAY


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.