Home › ENGINE ยท 2TR-FBE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ROD ASSEMBLY
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.

  1. Read the value displayed on the intelligent tester.

    Standard Voltage:
    Accelerator Pedal Operation
    Accel Sensor Out No. 1
    Accel Sensor Out No. 2
    Released
    0.5 to 1.1 V
    1.2 to 2.0 V
    Depressed
    2.6 to 4.5 V
    3.4 to 5.0 V

    If the result is not as specified, check the accelerator pedal, wire harness and ECM.