DTC P0504 Brake Switch "A" / "B" Correlation |
| Signal (ECM Terminal) | Brake Pedal Released | In Transition | Brake Pedal Depressed |
| STP | OFF | ON | ON |
| ST1- | ON | ON | OFF |
| DTC Detection Drive Pattern | DTC Detection Condition | Trouble Area |
| Depress and release brake pedal with ignition switch to ON | Conditions (a), (b) and (c) continue for 0.5 seconds or more (1 trip detection logic): (a) Ignition switch to ON. (b) Brake pedal is released. (c) The STP signal is off when the ST1- signal is off, or the STP signal is on when the ST1- signal is on. |
|
| DTC No. | Data List |
| P0504 | Stop Light Switch |

| 1.CHECK STOP LIGHT SWITCH ASSEMBLY (TERMINAL B VOLTAGE) |
![]() |
Disconnect the stop light switch connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S14-2 - Body ground | Always | 11 to 14 V |
| S14-3 - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Stop Light Switch) |
Reconnect the stop light switch connector.
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK ECM (STP AND ST1- VOLTAGE) |
![]() |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Brake Pedal Condition | Specified Condition |
| E5-14 (ST1-) - Body ground | Released | 11 to 14 V |
| Depressed | 0 to 3 V | |
| E5-15 (STP) - Body ground | Released | 0 to 3 V |
| Depressed | 11 to 14 V |
| *a | Brake Pedal Depressed |
| *b | Brake Pedal Released |
| *c | Component with harness connected (ECM) |
|
| ||||
|
| ||||
| 4.REPLACE STOP LIGHT SWITCH ASSEMBLY |
Replace the stop light switch assembly (Click here).
|
| ||||
| 5.REPLACE ECM |
Replace the ECM (Click here).
|
| ||||
| 6.REPAIR OR REPLACE HARNESS OR CONNECTOR |
Repair or replace the harness or connector.
| NEXT | |
| 7.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON and turn the tester on.
Depress and release the brake pedal.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||