VEHICLE STABILITY CONTROL SYSTEM > CALIBRATION |
| DESCRIPTION |
Follow the chart below to perform calibration.
| Part to be Replaced/Operation | Necessary Operation |
| Skid control ECU (Brake actuator assembly) | Yaw rate and acceleration sensor zero point calibration |
| Yaw rate sensor assembly |
|
| Front wheel alignment adjustment |
|
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When Using Intelligent Tester) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
for Automatic Transmission:
Check that the shift lever is in P and apply the parking brake.
for Manual Transmission:
Check that the shift lever is in neutral and apply the parking brake.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/ TRC / Utility / Reset Memory.
Turn the ignition switch off.
Perform zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
for Automatic Transmission:
Check that the shift lever is in P and the parking brake is applied.
for Manual Transmission:
Check that the shift lever is in neutral and the parking brake is applied.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Switch the skid control ECU (brake actuator assembly) to Test Mode using the intelligent tester. Enter the following menus: Chassis / ABS/VSC/TRC / Utility / Test Mode.
After Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
Check that the slip indicator light blinks in the Test Mode pattern (0.125 seconds on and 0.125 seconds off).
Turn the ignition switch off and disconnect the intelligent tester.
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When not Using Intelligent Tester) |
Clear the zero point calibration data.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
for Automatic Transmission:
Check that the shift lever is in P and apply the parking brake.
for Manual Transmission:
Check that the shift lever is in neutral and apply the parking brake.
Turn the ignition switch to ON.
![]() |
Using SST, connect and disconnect terminals 12 (TS) and 4 (CG) of the DLC3 4 times or more within 8 seconds.
| *a | Front view of DLC3 |
Check that the slip indicator light blinks.
Perform zero point calibration of the yaw rate and acceleration sensor.
Turn the ignition switch off.
Check that the steering wheel is in the straight-ahead position.
for Automatic Transmission:
Check that the shift lever is in P and the parking brake is applied.
for Manual Transmission:
Check that the shift lever is in neutral and the parking brake is applied.
![]() |
Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.
| *a | Front view of DLC3 |
Turn the ignition switch to ON to enter Test Mode.
After Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
Check that the slip indicator light blinks in the Test Mode pattern (0.125 seconds on and 0.125 seconds off).
Turn the ignition switch off and disconnect SST from the DLC3.