DTC C1401 Front Speed Sensor RH Malfunction |
DTC C1271 Low Output Signal of Front Speed Sensor RH (Test Mode DTC) |
DTC C1272 Low Output Signal of Front Speed Sensor LH (Test Mode DTC) |
DTC C1402 Front Speed Sensor LH Malfunction |

| DTC Code | DTC Detection Condition | Trouble Area |
| C1401 C1402 | One of the following conditions is met:
|
|
| C1271 C1272 | Stored during Test Mode. |
|
| 1.CHECK FRONT SPEED SENSOR INSTALLATION |
Turn the ignition switch off.
![]() |
Check the speed sensor installation (Click here).
| *1 | Front Speed Sensor |
| *a | No clearance |
| *b | CORRECT |
| *c | INCORRECT |
|
| ||||
| OK | |
| 2.INSPECT FRONT SPEED SENSOR TIP |
Turn the ignition switch off.
Remove the front speed sensor (Click here).
Check the speed sensor tip.
|
| ||||
| OK | |
| 3.INSPECT FRONT SKID CONTROL ROTOR |
Turn the ignition switch off.
Remove the front skid control rotor (Click here).
Check the front skid control rotor.
|
| ||||
| OK | |
| 4.READ VALUE USING INTELLIGENT TESTER (FR/FL WHEEL SPEED) |
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List, and then drive the vehicle.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Wheel Speed | Front speed sensor RH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Actual wheel speed | No large fluctuations when driving at a constant speed. |
| FL Wheel Speed | Front speed sensor LH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Actual wheel speed | No large fluctuations when driving at a constant speed. |
Check the speed value output from the speed sensor displayed on the intelligent tester.
|
| ||||
| OK | ||
| ||
| 5.REPLACE FRONT SPEED SENSOR |
Turn the ignition switch off.
Replace the front speed sensor (Click here).
| NEXT | |
| 6.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the ignition switch off.
Start the engine.
Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | ||
| ||