DTC C1432 Steering Angle Sensor Power Source Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1432 | A steering angle sensor power supply malfunction signal is received from the steering angle sensor. |
|

| 1.CHECK TERMINAL VOLTAGE (BAT TERMINAL) |
Turn the ignition switch off.
Disconnect the steering angle sensor (spiral cable sub-assembly) connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S31-6 (BAT) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor [Spiral Cable Sub-assembly]) |
|
| ||||
| OK | |
| 2.CHECK TERMINAL VOLTAGE (IG TERMINAL) |
Turn the ignition switch off.
Disconnect the steering angle sensor (spiral cable sub-assembly) connector.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| S31-5 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector (to Steering Angle Sensor [Spiral Cable Sub-assembly]) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (ESS TERMINAL) |
Turn the ignition switch off.
Disconnect the steering angle sensor (spiral cable sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S31-2 (ESS) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||