VEHICLE STABILITY CONTROL SYSTEM > TS and CG Terminal Circuit |

| 1.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) |
Turn the ignition switch off.
Disconnect the skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S25-33 (TS) - D3-12 (TS) | Always | Below 1 Ω |
| S25-33 (TS) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D3-4 (CG) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||