DTC P0781 1-2 Shift (1-2 Shift Valve) |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0781 | Gear required by the ECM does not match the actual gear when driving (2 trip detection logic*1, 1 trip detection logic*2). |
|
| 1.CHECK DTC OUTPUT (IN ADDITION TO DTC P0781) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and push the intelligent tester main switch ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the intelligent tester.
| Display (DTC output) | Proceed to |
| Only P0781 is output | A |
| P0781 and other DTCs | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Control the Shift Position | Operate shift solenoid valve and set each shift position |
| It is possible to check the operation of the shift solenoid valves. [Vehicle Condition] The vehicle speed is 50 km/h (30 mph) or less. |
|
| ||||
| OK | |
| 3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
![]() |
Remove the test plug on the transmission case center right side and connect SST.
Connect the intelligent tester to the DLC3.
Start the engine and warm it up.
Measure the line pressure with SST.
Turn the intelligent tester ON.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
Follow the instructions on the tester and perform the Active Test.
Measure the line pressure with SST.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Control the Line Pressure Up* | Operate shift solenoid valve SLT and raise line pressure | ON or OFF
| [Vehicle Condition]
|
|
| ||||
| OK | |
| 4.CLEAR DTC AND PERFORM RUNNING TEST |
Clear the DTC, and check for the DTC again after conducting the "Test Monitor Drive Pattern for ECT" (Click here).
|
| ||||
| OK | ||
| ||