RADIATOR > ON-VEHICLE INSPECTION |
| 1. INSPECT RADIATOR CAP SUB-ASSEMBLY |
![]() |
Measure the valve opening pressure.
If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean the part(s) with water and finger scouring.
Check that 1, 2 or 3 is not deformed, cracked or swollen.
Check that 3 and 4 are not stuck together.
Apply engine coolant to 2 and 3 before using a radiator cap tester.
When using the cap tester, tilt it more than 30°.
![]() |
Pump the cap tester several times and check the maximum pressure*.
Pumping speed: 1 pump per second
*: Even if the cap cannot maintain the maximum pressure, it is not a defect.
| Item | Specified Condition |
| Standard value (for brand-new cap) | 93 to 123 kPa (1.0 to 1.3 kgf/cm2, 13.5 to 18 psi) |
| Minimum standard value (for used cap) | 79 kPa (0.8 kgf/cm2, 11.4 psi) |