FUEL INJECTOR > INSPECTION |
| 1. INSPECT INJECTOR |
![]() |
Measure the resistance between the terminals.
| 2. INSPECT INJECTION VOLUME AND LEAKAGE |
![]() |
Assemble SST as shown in the illustration.
Discharge the fuel system pressure .
Disconnect the fuel main tube (fuel tube connector) from the fuel filter.
Remove the bolt and disconnect the fuel pressure regulator from the fuel delivery pipe.
![]() |
Connect SST to the fuel filter.
![]() |
Install the fuel pressure regulator to SST (union) with the 2 bolts.
Install the O-ring to the injector.
![]() |
Assemble SST as shown in the illustration.
![]() |
Pass SST (tie band) through the loop on the handle of SST (clamp) to secure SST (clamp) to SST (adapter).
Check that SST (clamp) and SST (adapter) cannot be easily separated.
Install a vinyl tube to the injector.
Put the injector into a graduated cylinder.
Operate the fuel pump.
Turn the ignition switch ON.
Push the intelligent tester main switch ON.
Select the Active Test and enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.
![]() |
Check the fuel leakage.
In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage rate from the injector.