FUEL INJECTOR > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
Remove the front driver side scuff plate.
Using a screwdriver, detach the 7 claws.
Using a clip remover, detach the 3 clips and remove the scuff plate.
![]() |
Turn up the floor carpet and disconnect the joining connector, as shown in the illustration.
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.
Crank the engine again, and then check that the engine does not start.
Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.
Connect the fuel pump connector.
Install the front driver side scuff plate.
Clear the DTCs (Click here).
| 2. PRECAUTION |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE INTAKE AIR CONNECTOR |
Disconnect the No. 2 ventilation hose.
Disconnect the vacuum hose.
Loosen the 2 hose clamps and remove the 2 bolts and disconnect the intake air connector.
| 5. REMOVE THROTTLE BODY |
Disconnect the throttle position sensor and control motor connector.
Disconnect the 2 water by-pass hoses.
![]() |
Remove the 2 bolts, 2 nuts and throttle body.
Remove the gasket.
| 6. DISCONNECT FUEL HOSE |
![]() |
Disconnect the No. 2 fuel hose from the pressure regulator.
Disconnect the No. 1 fuel hose from the pulsation damper.
Detach the lock claw by lifting up the cover, as shown in the illustration.
Check for foreign matter on the pipe and around the connector before disconnecting. Clean if necessary.
![]() |
If the connector and the pipe are stuck together, pinch the connector, and push and pull the pipe to disconnect them.
Check for foreign matter on the seal surface of the disconnected pipe. Clean if necessary.
![]() |
To protect the disconnected pipe and connector from damage and contamination, cover it with a plastic bag.
| 7. REMOVE FUEL DELIVERY PIPE |
![]() |
Disconnect the 4 clamps and wire harness from the delivery pipe.
Disconnect the vacuum hose.
![]() |
Disconnect the 4 injector connectors.
Remove the 2 bolts and delivery pipe together with the 4 injectors.
![]() |
Using 2 screwdrivers, pry out the 4 spacers from the cylinder head.
| 8. REMOVE FUEL INJECTOR |
![]() |
Pull out the 4 injectors from the delivery pipe.