FUEL FILTER > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
Remove the front driver side scuff plate.
Using a screwdriver, detach the 7 claws.
Using a clip remover, detach the 3 clips and remove the scuff plate.
![]() |
Turn up the floor carpet and disconnect the joining connector, as shown in the illustration.
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch OFF.
Crank the engine again, and then check that the engine does not start.
Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.
Connect the fuel pump connector.
Install the front driver side scuff plate.
Clear the DTCs (Click here).
| 2. PRECAUTION |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE CANISTER |
![]() |
Disconnect the 3 hoses from the canister.
![]() |
Detach the canister from the stay and remove the canister.
| 5. DISCONNECT FUEL HOSE |
![]() |
Disconnect the hose from the clamp.
Pinch and pull the fuel hose's connector to disconnect it from the fuel filter's upper pipe.
| 6. REMOVE FUEL MAIN TUBE |
![]() |
Remove the fuel tube grommet.
Detach the lock claws by lifting up the connector cover. Then pinch and pull the fuel main tube's connector to disconnect it from the fuel filter's lower pipe.
| 7. REMOVE FUEL FILTER |
![]() |
Remove the 3 nuts and fuel filter.