OIL FILTER > REPLACEMENT |
| 1. REMOVE NO. 2 ENGINE UNDER COVER |
| 2. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil drain plug and drain the oil into a container.
Clean and install the oil drain plug with a new gasket.
| 3. REMOVE OIL FILTER SUB-ASSEMBLY |
![]() |
Using SST, remove the oil filter.
| 4. INSTALL OIL FILTER SUB-ASSEMBLY |
Check and clean the oil filter installation surface.
Apply clean engine oil to the gasket of a new oil filter.
![]() |
Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.
Using SST, tighten the oil filter.
Depending on the work space available, choose from the following.
If enough space is available, use a torque wrench to tighten the oil filter.
| 5. ADD ENGINE OIL |
Add fresh engine oil.
| Oil Grade | Oil Viscosity (SAE) |
| API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource- Conserving" or ILSAC multigrade engine oil |
|
| API grade SL, SM or SN multigrade engine oil |
|
| Item | Capacity |
| Drain and refill without oil filter change | 5.3 liters (5.6 US qts, 4.7 Imp. qts) |
| Drain and refill with oil filter change | 5.6 liters (5.9 US qts, 4.9 Imp. qts) |
| Dry fill | 6.3 liters (6.7 US qts, 5.5 Imp. qts) |
Install the oil filler cap.
| 6. INSPECT FOR OIL LEAK |
Start the engine, and check that there are no oil leaks after performing maintenance.
| 7. INSPECT ENGINE OIL LEVEL |
Warm up the engine, and then stop the engine and wait for 5 minutes.
If the oil level is low, check for leakage and add oil up to the full level mark.
Check that the engine oil level is between the low level and full level marks on the dipstick.
If low, check for leakage and add oil up to the full level mark.
| 8. INSTALL NO. 2 ENGINE UNDER COVER |