Home › ENGINE ยท 2TR-FBE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > REMOVAL

for Preparation Click here



1. REMOVE DRIVE BELT


    A099194E01
  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.



2. REMOVE TENSIONER PULLEY

NOTICE:
Perform the following procedure when it is necessary to replace the tensioner pulley.

  1. Remove the engine oil level dipstick.

  1. Remove the bolt, engine oil level dipstick guide and O-ring.

    HINT:
    Cover the dipstick guide hole to prevent foreign matter from entering it.



    G035081E06
  1. Remove the bolt, dust seal and tensioner pulley.